FORMAT SANDISK FOR MAC USING WINDOWS 10 DRIVER

SanDisk Extreme’s LED will turn on once inserted into the USB 3.0 Port but then turn off approximately one second later and will not be detected by the ComputerĪfter running tedious and unsuccesful solutions and procedures found online e.g deleting registries from the SanDisk Extreme, trying to assign it a Drive letter, resetting computer to factory settings, I found a solution. SanDisk Extreme’s LED when inserted to the drive will stay on and the USB flashdrive will not be detected by the Computer SanDisk Extreme was detected and usable when inserted into 2.0 USB ports but not in USB 3.0 ports.

SanDisk Extreme would be detected in the Computer, but wouldn’t appear as a removable storage device in the “My Computer” window

FORMAT SANDISK FOR MAC USING WINDOWS 10 DRIVER

SanDisk Extreme couldn’t be given a driver label in Computer Management under “Disk Management”. Instead, it was being detected as various different Disk Drives. SanDisk Extreme wasn’t being detected as “SanDisk Extreme” in Device manager. I was looking online for solutions because my SanDisk Extreme 64GB USB 3.0 Flashdrive had the following problems You can get the detailed steps of disabling write protection in this article:

You are supposed to remove the write protection. In regard to the recovery software, you can read some articles of recovery thing to help you make a right decision:įrom you description, I think your drive may be write protected. After all, nobody can make sure whether the following steps or measures can damage the data. You should restore the data there with the help of recovery software in case of any data loss.

In you case, you can only read the data, cannot copy or format it. Even though I am not exactly know what caused your problem, I also would like to give you some suggestion.ġ.You should firstly back up you data for the safety of it.

Format sandisk for mac using windows 10